The Filter - remix for another kind of Pogo pins

Wasn't intended to publish, but since some people asked me on VoronDesign for the files, i have decided to share it. I got the steps from github and the missing one  directly from nateb16 (nate5815 on discord) that i greatly thanks for his amazing job.

Since the original version was designed for this type of Pogo, and that i didn't want the USB cable at the back, i have decided to remix it for this kind of Pogo (ø 10 mm / 3A / 2 pins / 5 mm deph) and the original wasn't adapted for.

Remixed then :

• the center filter housing
• the center mounting bracket
• the left side mag mount
• the right side mag mount

Else was ok (all Lids, left and side housing) and can be found there : https://github.com/nateb16/VoronUsers/tree/master/printer_mods/nateb16/THE_FILTER

Pogo i used (will need 3 if you are planning to install side and center and only one if center only) : https://fr.aliexpress.com/item/1005004182554268.html?spm=a2g0o.order_list.order_list_main.75.19be5e5bDBANyI&gatewayAdapt=glo2fra

Also you can find on my printables the Hub and the wiring guide i used on my pics.

I also ran quite some measurements before and after installing The Filter (to compare to Nevermore V5) to see the improvement. Had 2 NTC 100 K thermistor, one at the back of the gantry, and one at the top front of the frame near the doors. I can assume that Nevermore is heating/blowing to the top of the enclosure first, when The Filter is heating/blowing to the middle of the enclosure around the gantry/head, then the top of the enclosure. That's obvious you would say. But actually, it clearly heating almost 1.5x to 2x faster than Nevermore (obvious again with 2 more fans).

On the graph i compared (with the 2 thermistor each time, during 1 hour heatsoak) :

• With Nevermore V5 and no bath towel (cheap tip to improve insulation) on Voron
• With Nevermore V5 with bath towel on Voron
• The Filter 4 fans with bath towel

You can see the graph on the pics i joined as well.