FormD T1 v2 Anti-Sag Supports for RTX 4080/4090 Founders Edition

This is a set of different supports and braces that can be used to prevent sagging of RTX 4080 & 4090 Founders Edition GPU's in the FormD T1 v2 (and v2.1).  

The two braces (short & long) attach to the case spine and provide support for the font of the card when the case is oriented in the most common position (horizontal with case fans on top).  The short brace can be installed without any component disassembly with a single small (4" / 100mm) ziptie or M3 screw + nut.  The long brace is secured by removing the existing screw holding the PSU frame to the spine and replacing with a CSM3-8 screw.

The two full support variants completely fix the front of the GPU to the front case panel and prevent movement in the X, Y, and Z directions.  These are the most secure option and provide protection when moving or traveling with the case.  The 1- and 2-piece supports both attach to the GPU with two CSM3-5 screws and to the case with two or three CSM3-8 (up to CSM3-12 length) screws.  To install these supports, stand the case upright, unscrew the case front panel from the frame, and shift it aside to allow access to the GPU front.  Attach the mono support or 2-piece support post to the GPU.  If using the 2-piece design, attach the larger support portion to the front panel using the holes shown in the photos.  Align and carefully replace the front panel on the frame. 

06/OCT/2023 Update:  Added small cutout to the Support Bracket and Mono Support models for compatibility with the v2.1 two-tone front panel design.