July 29, 2023
Description
40mm wide 1/4" NPT mount and a 1/4" loc-line lamp, meant for two 100mm strips of 10mm wide LED strip lighting. Using two pieces of loc line and a 1/4" NPT adapter (like $8 for the loc line kit).
M3 screws for the NPT mount.
The strip holder doesn't have a hole in it, because I printed it standing on it's end (loc-line up) and it can't bridge if there's a hole in the middle. I just drilled it out afterwards to pass the wiring through.
It'll be a jerk to assemble if you print it out of PLA (PETG recommended), but it is possible. Easier with the correct loc-line pliers. The alternative is to print it a tiny bit oversized (or soften it with a heat gun) and put a little CA glue in the cup. Won't stick to the loc-line, but it will tighten the fitting back up once you get it on.
Printer:
SecKit Sk-Go
Supports:
No
Resolution:
.2
Infill:
20
Filament: 3D Solutech PETG/PLA Black
Notes:
Shouldn't need support, if the lamp is printed on it's end (loc-line up), it's an easy bridge at the top. Brim would be wise.
NPT mount prints great sitting normally, threads fit great.License:
Creative Commons — Attribution
9
hypnolobster
