Pulley Cover for AnyCubic i3 Mega (rear only)

This is a pulley cover for the rear Y axis pulley on the Anycubic i3 Mega (I guess it's a gear attached to a stepper motor, not exactly a pulley, but that's what everyone is calling it so we'll go with that)

I decided I wanted some pulley covers, and I found one that someone else made for the front, but not too many for the rear. I didn't like the look of the ones I did find for the rear, and the one I tried sat higher than I liked, and also didn't stay flat well because it was only held down on one side. This is a bit lower profile, and attached with two screws to help keep it lying flat.

Check out my other Anycubic i3 Mega accessories at: https://www.printables.com/social/55222-tyler/collections/95780

Print instructions

Printer Brand: Anycubic
Rafts: No
Resolution: 0.15
Filament: Filaments.ca EconoFil PLA (Black)
Notes: Print it in the supplied orientation. It requires a lot more support than if you flipped it upside down, but it ends up looking a lot nicer this way in my opinion.

If this design was useful to you, please post a make!