Op-Art Tiger Portrait (Filament Painting)

6 Color HueForge model. Op-Art Tiger Portrait filament painting made using Sunlu and Esun Pla+ filaments.

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm

(I recommend the following speed settings for the bambu with 0.04 layers, inner walls, outer walls and gap infill - 200mm/s, sparse infill, internal solid infill and top surface - 150mm/s)

Filaments Used:
PLA Sunlu PLA+ Black Transmission Distance: 0.6
PLA Esun PLA+ Brown Transmission Distance: 1
PLA Esun PLA+ Fire Engine Red Transmission Distance: 5
PLA Esun PLA+ Orange Transmission Distance: 10
PLA Sunlu PLA+ Pure Yellow Transmission Distance: 5
PLA Sunlu PLA+ White Transmission Distance: 6

Swap Instructions:
Start with Black
At layer #10 (0.64mm) swap to Brown
At layer #14 (0.8mm) swap to Fire Engine Red
At layer #15 (0.84mm) swap to Orange
At layer #19 (1mm) swap to Pure Yellow
At layer #21 (1.08mm) swap to White for the rest.

This is a filament blending model, I would recommend trying to match the td as close as possible if not using the exact filaments to get the best results.

Use the exact numbers in your slicer to match up properly.

Two different size models are supplied and designed to print with 0.4 nozzle
 

**If Scaling the model make sure not to adjust the Z-Height of the model**