Spitfire (Filament Painting)

6 Color HueForge model. Spitfire filament painting made using Bambu Pla Basic filaments.

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm

(I recommend the following speed settings for the bambu with 0.04 layers, inner walls, outer walls and gap infill - 200mm/s, sparse infill, internal solid infill and top surface - 150mm/s)

Filaments Used:
PLA Bambu PLA Basic Black Transmission Distance: 0.6
PLA Bambu PLA Basic Blue Gray Transmission Distance: 3
PLA Bambu PLA Basic Brown Transmission Distance: 2
PLA Bambu PLA Basic Orange Transmission Distance: 10
PLA Bambu PLA Basic Yellow Transmission Distance: 6
PLA Bambu PLA Basic Jade White Transmission Distance: 5

Swap Instructions:
Start with Black
At layer #12 (0.6mm) swap to Blue Gray
At layer #17 (0.8mm) swap to Brown
At layer #19 (0.88mm) swap to Orange
At layer #21 (0.96mm) swap to Yellow
At layer #23 (1.04mm) swap to Jade White for the rest.

This is a filament blending model, I would recommend trying to match the td as close as possible if not using the exact filaments to get the best results.

Use the exact numbers in your slicer to match up properly.

Two different size models are supplied and designed to print with 0.4 nozzle
 

**If Scaling the model make sure not to adjust the Z-Height of the model**