August 8, 2023
Description
The WowGo 3 board comes with a wall hook, but I wanted something a little less invasive, so I made an easy to use longboard stand.
This is a stand created specifically for this model longboard. It is printed in two parts, connected by a simple puzzle piece design. One side has a small area for your throttle so you can store that next to it as well.
You can modify the stand to your liking at the following Tinkercad link:
https://www.tinkercad.com/things/6EWJ0BV6CAp
Some of the board specs for reference if you would like to modify:
Wheel Diameter: 90mm
Wheel Height: 60mm
Wheel apart distance: 120mm
Total wheel to wheel distance: 280mm
Tip of board to wheel distance: ~45mm
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
.20
Infill:
15%
Filament: Inland PLA Orange
Notes:
3 walled print
I haven't tested it for that long, but the 3 walls and 15% infill seems to be enough to accommodate this 18lb board.The two parts fit together pretty well and can be handled without them falling apart. There is a little bit of give around the area where they connect, so you can put glue or modify to make it tighter, but since you shouldn't really ever touch it, it should be fine.
I was thinking about trying to put some sort of rubber feet on them, but it doesn't seem to need them on the wooden floor I had tested it on. Just make sure to have a decent lean on the wall so it doesn't tip over.
License:
Creative Commons — Attribution
11
LegendaryCheez
