15 degree tilt Support for Wansview Q5 Camera

When installing Wansview brand cameras at home, especially the Q5 models, I needed to tilt them to the bottom, because I wanted to place them on top of a cabinet.

I did not want to drill to put their arm, so I decided to make this support, to put for example on top of a piece of furniture, and which allows the camera to tilt down by about 15 °.
Just in case, I still put some screw holes on the rear so that you could attach this bracket to the wall if needed.

I hope this design can be used by others.

Forgive the imperfections, I'm not a 3D design pro, I used TinkerCad to do this ;)

For better results, I have found that it is needed to print at a minimum of 25% fill, because on how the filament is put on the fill pattern to create the slope of 15°

So in summary, you need to have a tight fill pattern.