Shoe rack with copper tubes and wooden boards

As a family you got a lot of shoes in the entree. The old shoe rack was too small. So we built a bigger one.

Other components needed

7xTubes outer diameter 18mm length as desired
3xWooden boards 100x18mm length as desired

Print instructions

I printed it in PLA and PETG it doesn't matter for this design, the choice is yours.
I would recommend to use a brim, because the parts a large and tend to warp.

For the assembly I also used 18mm remnants of the copper tubes to join the individual parts. Then glue the contact surfaces with super glue.

To prevent the shoe rack from slipping, I glued two rubber surfaces to the bottom.