Wera 2go lid holder

I was annoyed that the lid of the Wera 2go toolbox always flaps back as you open it so I designed these two parts which stops it. The body-part clips onto the body of the toolbox and has a tight fit. On the  lid piece I sticked a piece of velcro so it holds onto the velcro strip of the lid. For the absorber I used steelwire were i clamped the ends to a loop an covered the clamp with a heat shrink tube but you can also use cord.

I used M3 threaded inserts from CNC Kitchen for better durability but i also uploaded a version for M3 screws with a little bit undersized holes. 

For assembly I used 4x M3x10 screws and 2 washers for each screw and glued them in with loctite.