DIY Planter - Wall Mount - Minimalist - 120mm

Printing instructions for the planter:

Infill density for waterproofing: ≥30%, Infill type: Gyroid

I printed it with no support - the only problematic part is the top edge engaging with the cleat on the back of the planter - depending on your bridging capabilities & slicer it should be fine but - be aware!

It fits perfectly with the DIY Planter - Drainage Pot - 120mm - Vase Mode I have already designed.

Printing instructions for the cleat:

Infill density for waterproofing: ≥50%, Infill type: Gyroid (I am currently printing with 80% infill as it does not make that much difference and I have hung some heavier plants now).

Mounting instructions:

You will need 2 countersunk screws with a thread diameter ≤5mm.

Simply screw the cleat edge side up to your wall and slide the planter onto it. Make sure that the screw heads are flush with or below the face of the cleat.

Have fun with this model.