Toyota Pickup Hilux Center Gauge Pod

Model requires greater than 225mm print bed, but this was meant for a third gen Toyota Pickup/Hilux, but likely fits other Toyota of the era with minimal fitting.

I recommend keeping your infill/walls high and running your print speed SUPER SLOW to prevent deformities. If those gauge holes get squashed from running too fast of a print speed, they won't fit.

I don't have any advice for supports. They were a huge pain to remove for me and I ended up wet sanding until it looked halfway decent. Let me know if you find an easy way to set that up, and I'll add it here.

You are free to upload this anywhere you like and share files in any non-commercial way. You are free to print and sell this as a physical good, but the price must not exceed the cost of a roll of the filament used, plus shipping. You are free to modify the .ipt in any way. I made this to keep this old truck on the road, and that's all I want out of the deal. Happy wrenching.