Aperture Science Portal Button Wireless Charger

I had this Wireless Charger and wanted to turn it into a Portal themed one, so I designed this to fit around the charger, with the cable passing through one of the legs.

You will need:

Darker Grey/Black filament for the Legs

Dark Grey filament for the Base and Leg Covers

Lighter Grey/White filament for the insert pieces

Light Blue filament for the logo and accent pieces (I used glow in the dark blue)

Red filament for the Button Top

I printed everything out of PLA except for the button top, which I used TPU for to get a little more grip on the back of the phone while charging.

I printed everything in 0.1 mm layer height to have less visible layer lines.

After printing, make sure to use a flat surface, and glue the legs into the base, choosing which way you want the cord of the charger to go. 

Once the legs are attached, glue the leg covers on top of each leg, making sure to glue the cable cover ones to the correct leg.

The side inserts and blue accents can be glued together, and use a little black marker or black paint on the logo piece to outline the companion cube logo.

I took the top surface of the charger off by removing the rubber feet and unscrewing the screws on the bottom. I don't think that is 100% necessary but I had good luck doing that to mine.