'Sunlu' colosseum (Filament Painting)

5 colour HueForge model. ‘Sunlu colosseum’ filament painting made using Sunlu pla+ filaments (as seen on sunlu website under hueforge filament packs)

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA Sunlu PLA+ Black Transmission Distance: 0.6
PLA Sunlu PLA+ Red Transmission Distance: 8
PLA Sunlu PLA+ Orange Transmission Distance: 10
PLA Sunlu PLA+ Pure Yellow Transmission Distance: 5
PLA Sunlu PLA+ White Transmission Distance: 6

Swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to Red
At layer #10 (0.88mm) swap to Orange
At layer #12 (1.04mm) swap to Pure Yellow
At layer #13 (1.12mm) swap to White for the rest.
 

This is a filament blending model, I would recommend trying to match the td as close as possible if not using the exact filaments to get the best results

Use the exact numbers in your slicer to match up properly.

model can be resized but keep the ‘Z’ height the same, designed to print with 0.4 nozzle