'Sunlu' Penguin (Filament Painting)

4 colour HueForge model. ‘Sunlu Penguin’ filament painting made using Sunlu pla+ filaments (as seen on sunlu website under hueforge filament packs)

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA Sunlu PLA+ Black Transmission Distance: 0.6
PLA Sunlu PLA+ Blue Transmission Distance: 3.5
PLA Sunlu PLA+ Sky Blue Transmission Distance: 4
PLA Sunlu PLA+ White Transmission Distance: 6

Swap Instructions:
Start with Black
At layer #6 (0.56mm) swap to Blue
At layer #9 (0.8mm) swap to Sky Blue
At layer #10 (0.88mm) swap to White for the rest.
 

This is a filament blending model, I would recommend trying to match the td as close as possible if not using the exact filaments to get the best results

Use the exact numbers in your slicer to match up properly.

model can be resized but keep the ‘Z’ height the same, designed to print with 0.4 nozzle