Interlocking vase mode bigger drawers

I merged two drawers, increased height to make it fit with two wide drawers, and voila, nothing too crazy.

It's not perfect, bambu will ask to repair it, but I didn't see any change after repair so good enough to me.

I'm printing these to go with 150% scaled up wide drawers from the original post (https://www.printables.com/fr/model/51905-interlocking-vase-mode-drawers/remixes)

So beware of the scale before printing them.

I'm printing at 0.8mm nozzle 0.52 layer width. Takes 5hours to print both in vase mode at ludicrous speed. 8h30 at normal speed.

Takes 427g of filament so could be improve to add holes. But if you do that, do it with creator's V2 instead, this version is outdated.

I make sure the first 1-2 layers are correct before going full speed for the sleeve.

For the draw you can go full speed as soon as outside walls are printed.

I don't care for attribution but selected same licence as original creator. Attribution should go to them.