I was missing the possibility to tilt the LED light of the fumetractor in a way to get a better light on my parts which I was soldering. So I decided to create a design with a hinge to add this future to the fumetractor.
For links to the shop to get your fumetractor, see down below.
Additional parts:
- 5x M3 nut
- 2x M3 washer & 2x 10mm M3 Screw (used to mount the hinge to the fumetractor)
- 2x 5mm M3 oval head screw (used to mount the LED bar to the hinge)
- 1x 40mm M3 cylinder head screw (used for the hinge)
Note:
- It could be that you have to extend the wires for the LED light by ~2cm.
- Use a 3mm drill to open the holes of partfumetractor_led_hinges_01.stl entirely.
Print instructions
Print Settings
- Infill: 20%
- Support: no
- Perimeters: 3
- Extrusion width: 0.45
- Layer height: 0.2, 1mm top/bottom thickness
- Filament: PETG, ASA, ABS and similar
derebbe
