Anycubic i3 Mega housing for 12864 LCD Graphic Smart Display Controller Board

This is a housing which can be used to mount a "12864 LCD Graphic Smart Display Controller Board" to an Anycubic i3 Mega.

BOM:

• 4x M3 5mm screw, 4x M3 washer (to mount the holders)
• 4x M3 10mm screw (to mount the screen)
• 2x M4 12mm screw, 2x M4 washer, 2x M4 nut (to mount the housing to the holders)

I won't provide an adjusted firmware to make this display operational with an Anycubic i3 Mega/S!

Print instructions

Print Settings

• Infill: 20%
• Support: no
• Perimeters: 6
• Extrusion width: 0.45
• Layer height: 0.2, 1mm top/bottom thickness
• Filament: PETG, ASA, ABS

Post-Printing

Rework the 4mm holes of the holders
To make the holes printable without using any supports, I closed them with a 0.2mm thin layer. Just use a screwdriver/knife or a 4mm drill to open them entirely again.