Subaru Forester Fog Light Adapter 09-13

Relatively basic adapter to mount newer LED fog lamps to the factory locations in SH Foresters 09-13.

I used a pair of washers and a flange nut to act as a spacer between the back of the adapter and the vehicle side mount to set the correct angle on the light.

I wasn't paying attention and kept trying to mount the bezel in the wrong orientation, wound up just cutting the center out of my OEM hole covers which fit nicely. The bezelsshould fit when placed in the correct orientation though.

Print with a material that can handle heat

Hardware list for reference:

Fog light: https://www.amazon.com/dp/B01K39R4HE?ref=ppx_yo2ov_dt_b_product_details&th=1

*NOTE: I needed to swap the wire orientation on one side of the plug adapter below to get the polarity correct for these lights. This was very easy to do as one side of the plug is easily de-pinned with a small poker.

Plug Adapter: https://www.amazon.com/dp/B07PB15WJJ?psc=1&ref=ppx_yo2ov_dt_b_product_details

M6 U-nuts qty. 2

M6x18 or similar qty. 2

M6x30 qty. 2

M6 flange nuts qty. 4

M6 flat washers qty. 8

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

.2

Infill:

Filament: Polymaker ASA Black

Category: Automotive