Slim Wallet V4.1 Money Clip

Updated 12-20-2020

Changes:

• The quick slot is back!
• The case has been extended just a bit to make the base flush
• The lever has been made slightly larger to compensate for the longer base
• The hinge has also been made slightly thicker.

Print tips

I've had good results printing the money clip at lower speeds so that the notch in the money clip is more square and not rounded.

A 0.15 mm or more fine layer height works well.

Post Printing

If the money clip does not fit correctly, shave a few layers out of the notch in the case.

Attributions:

This is a slightly different take on Pentland Designs' amazing Slim Wallet V4.0. Namely, it has a money clip and doesn't have the quick card access slot.

Some of the design inspiration for the money clip came from the wonderful MONEY CLIPS by YSoft_be3D

The design on the wallet is Pentland Designs' symbol. I included it in this remix as attribution only.

Why this design might be better than some of the other remixes

• There were almost no changes made to the original wallet's design
• The money clip actually holds money securely
• The money clip is more durable because the grain of the print runs vertical, not horizontal

Why this design might be worse than some of the other remixes

• The wallet is a bit more bulky

Planned updates

While this design is usable and printable in its current state, here's some planned improvements:

• a bit more tolerance on base of money clip (currently requires post-print slimming of Wallet Case base for money clip to fit)

Printing Notes

The money clip is meant to be printed on its side (as oriented in its STLs), this should give it more structural integrity.

Use supports for the Case and Cap because of the hinge

Check the original design for more in-depth printing tips