September 5, 2023
Description
A simple remix for a special someone. Was designed to take 10 16mm x 19mm wheel weights for stability although if printed with lots of shells it's pretty hefty. Attach the two pieces using super glue or epoxy.
I didn't use the wheel weights because of the heft but it was designed to take 10 of these in the base: 16x19mm weights
If you'd like to support me please check out my filament wishlist here or Paypal here
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
20%
Filament: Hatchbox PLA Black
Notes:
Hand/Base:
Support density 40% or greater
Supports @45 degrees
5 shells/layers (Probably could get away with 3 layers)
Used brim (Optional)
*Supports shouldn't be necessary for 16x19mm wheel weight holes. Bridging should be sufficient
Cup:
*Used 4 shells (2-3 should be fine)
License:
Creative Commons — Attribution — Noncommercial
TheViralDIY
