September 2, 2023
Description
Do you hate those half meter long pieces of filament, which are not consumed by printer because the filament sensor is far away from extruder? Are you too lazy or busy to watch the printer feeding in the half meter long piece, just to push in the begining of new roll when the printer finally consumed it? Do you love nature so much, that your heart would break, if you trew away half meter of filament? Then this holder is going to change your life. You can finally spend some time with your family or your dog.
Easy one hand no tool install/uninstall from extruder head.
You will need 2pcs of magnets 6x2mm. But works even without them
Print in petg as shown on picture.
3d printing optimised model.
rev.1
added filament funnel-like guide, install to former place of filament runout sensor.
License:
Creative Commons — Attribution — Noncommercial
7
Koumak
