Baby bed raiser

This will raise the baby bed by 14cm. The raise support bed legs with a size of up to 4 by 4 cm.

Printed this on an Ender 3 Pro using eSun PLA +

I used the following settings:

Layer height: 0.2 mm
Wall thickness: 0.8 mm
Infill: 25% with cubic pattern
Nozzle temperature: 200°C
Bed temperature: 40°C
Supports are needed, I used Cura's tree support.

The model is printed upside down to reduce the supports needed to be printed.

I used a raft as well, but this should not be necessary.