Heltec Lora V3 Outdoor Case

Print settings
Print face down with supports only touching build plate (this will support the window)
0.2mm
100% infill

Water Resistance
1. A small bead of silicoln around the front of the screen should be sufficient, there is a groove in which I added to make the silicoln adhere better and stay in place.

2. put some silicoln on the intenna threads where it meets the case, inside and out.

Materials Required
Requires one M2 self tapper to secure the back of the case, preferably countersunk.

If you want me to do any modifications, let me know in the comment. Thanks. :)


Note: The antenna hole may be too tight, so test it, then you can either use a deburring tool, or a drill bit to open it up slightly. The tighness was to account for printer deviations, it's better to be too small than too big.