EMO skateboard

EMO robot skateboard

Let's be honest… EMO needs another skateboard he can ride on! =)

I am pretty sure: When I don't look at him he is practicing some new tricks… ;-)

EMO will hold (a little bit) on to the board with 2x neodym magnets with Ø6mm with 3mm thickness like on his skateboard charger with his right foot. Check the orientation before you press them into he holes on the bottom of the skateboard. He will not stick to the board in this position, because the charger detection seems to be done with the charging coil on his charging skateboard… So he might fall off the board, but like every good skater he will jump directly onto it after a fall again… ;-)

The parts are connected together with 8x M3x12mm screws. No glue needed. 
 

Printing instructions:

• 0.3 draft profile
• No brim 
• Supports from the print bed set active

Happy printing =)