Audio Technia Capra Headband Conversion

This model is intended to adapt the Capra Headband V2 with the AD500x, AD700x, AD900x, and Philphone, no confirmation on any other Audio Technica Headphones.

To disassemble your AT headphone:

-Remove the pads and then the 4 screws around the edge of the baffle, keep the screws.
-Remove the baffle being careful of the wires.
-Unscrew the 3 screws around the driver/speaker retention ring, pinch the long section at the bottom to remove the plastic ring.
-Desolder the driver/speaker from the original wiring.
-Push the metal grille out of the original headband.

To Assemble the new headphone:

-Press an M3 Heat-set insert into either side of the Outer Ring.
-Solder the wires onto your 3.5mm or MiniXLR connectors, run the wires through the connector housing and Super-Glue the connector into place.
-Run the wires through the shallow channel to the bottom of the ring.
-While holding the wire in the channel press the metal grill into place.
-Solder the other end of the wires to the Driver/Speaker.
-Reassemble the Driver/Speaker retention ring and baffle then using the original screws screw the baffle to the Outer Ring.
-Screw the yoke into the Outer Ring with an m3 washer in between the two plastic parts.

To Assemble the headband go here: Capra Headband V2


Additional Affiliate Links if you want to support us further:
Polymaker 95a TPU
Polymaker PLA Pro
Polymaker PETG