The Bill - Hydroponic Pod Plant Supporter (Fits Gardyn, Lettuce Grow, iHarvest, and similar vertical gardens)

The Bill

I present you with The Bill, The Hydroponic plant supporter.

I made this for my wife's Gardyn Hydroponic Garden, it will also work in other brands too. Some of the smaller leggy plants needed extra support at the base. The Bill helps support the plant at the base and aids in its growth in the right direction.  Each Bill requires two small 2mm steel rods per 

Here are some some tips for this print:

• This is pretty easy to print standing upright but I recommend using a brim since print bed surface is minimal. 
• I noticed the tips of some of the steel rods needed to be filed down to fit. 
• The current tolerance is snug, however;
  • You may need to heat the rod if the tolerance is too tight
  • Use a tiny bit of glue if the tolerance is too loose.
• I used PETg for this print but PLA should be fine too. 

California Filament PETg (Get 25% off your first purchase)
Stainless Steel Rods 2mm x 75mm
Stainless Steel Rods 2mm x 50mm
Disclaimer: I get a small kickback for using these links to help produce 3D models for the community.

If you want to commercially reproduce this, please contact me.