The Hook on one of my backs was just gone by one day.
Designed a model based on the remaining hook, but optimized it for support free printing.
Found out about a newer, rotatable version with a separate tooth plate, so I quickly made a version for that one too.
DISCLAIMER: DOES NOT WORK WITHOUT BASE PLATE!
Additional Hardware needed:
- 1x M4 16mm screw
- 1x base plate. This sadly is hardly printable because of the tight gap (1mm). If the part is missing, you will have to improvise or order one online. Search for:
VAUDE threaded plate oval
or
VAUDE Gewindeplatte oval
Printing instructions / recommendations:
For both variants:
- Do not use PLA. Use at least PETG.
- Object should load in correct orientation, with the flat side of the hook face down
- 5 perimeters (0.4mm nozzle), 3 Perimeters (0.6mm nozzle)
For solid variant:
For adjustable variant:
- Objects should load in correct orientation, with the non-toothed face of the plate facing down
- I highly recommend 100% infill on the small tooth plate. Barely increases print time, but will make the plate much more rugged.
- You will want to use Supports for the tooth plate.
AzidMeister
