mini screw driver case

has your mini screw driver case deteriorated? (like mine)

here's your solution!

(don't know why I'm pitching this like its shark tank)

pretty straight forward, hinges clip together eliminating the need for screws or other parts

PRINT INSTRUCTIONS:

     case halves:

          60% infill

          supports

         enable z hop for top half (z hop is what its called for cura it may be different for other slicers

     Latch:

          100% infill

          no supports

     clips

          100% infill (not that it will matter)

Assembly:

         assemble as seen in the images

         super glue the clip where it will accommodate the screw driver

         Optional:

         the latch should be tight enough to hold the clip but to prevent it from falling off, use a soldering iron to melt the sides of the latch block to form a brim

if a soldering iron is not available, the nozzle of a hot glue gun will suffice.