Party glasses - 2024

A model of funny glasses for celebrating the arrival of the new year 2024.

Printing:

Print takes a little over 2 hours and I reccomend to use color-change during print, e.g. first 3 layers with one color and rest with black color. But of course you can go without color-change as well.

• Use PLA to bend the front part well in hot water.
• Use brim for the temples.
• Custom supports are ready for the revolute joint of the temples and work well for 0,2mm layerheight.

Post processing:

Also see images here https://www.printables.com/model/342945-party-glasses-2023.

1. Remove temple brims and clean the edges.
2. Bend the front frame a bit using hot water (or heat gun) and coffee saucer. Hot tap water was sufficient in my case.
3. Remove small support block from the temples (inside joint).
4. Try to insert piece of filament into the holes. The holes may probably need to be enlarged.
5. Slide the temples onto the frame and insert the filament.
6. Trim the end of the filament.
7. Enjoy the party ;)

Also check out:

https://www.youtube.com/channel/UChKp-968z1i5PN29gbR7YfA

https://www.cgtrader.com/rorys3d