Varia VS3 & 3.5 Coffee Grinder bean distributor

I am a great friend of the Varia VS3 coffee grinder!

For an optimal result, I always moisten my beans with 1-2 sprays of distilled water before grinding.

Unfortunately, this makes them a bit "sticky" and they often don't fall completely into the grinder. The enclosed bellows can usually press them down, but then the whole workplace around the grinder gets dirty :D

So here I have a small solution that gets all the beans into the grinder without you having to do anything or make your workplace dirty afterwards.

Optionally, there is the funnel as an insertion aid :)

Have fun with it!

Short Video:
https://www.instagram.com/reel/CxGU-ofB3k3/?utm_source=ig_web_copy_link&igshid=MzRlODBiNWFlZA==

Small Disclaimer:
I noticed  that the nut can loosen itself due to this attatchment if it is not screwed in place tight enough. So I would recommend to check that from time to time to avoid getting a uneven grinding result :) (My screw was a little loose after 1 Jear of daily use). 

My workflow:

1. Remove cap.

2. Moisten and insert beans.

3. Start the machine.

4. Remove funnel (beans should all be in the Varia container).

5. Put the cap back on.

6. Let the beans run through and continue to run empty for a few seconds.