Bambu Lab Horizontal Plate Holder

Space on my study room table comes as a premium and spare plates on a popular vertical stand would just get in the way and probably get knocked over at some point.

I've put anti vibration feet on the X1C which raised it some from the table so I've designed a horizontal plate holder.

It requires 23mm of height under the printer or higher.

Plates are generously supported in the middle and the plates won't sag so spare stickers can be stored as well.

It is designed to store 3 plates

NOTE!
Since it's printed vertically middle part turns to be 4 BIG completely unsupported fins until the last segment that bridges and connects everything and given the speed and Z hop on these printers there is some evident ringing.

Also note that this thing eats 350 grams of filament and takes about 8.5 hours to print in standard mode. In faster modes ringing would probably get much worse or even lead to a failed print.

There are many design changes that would make this part better which are clear to me now but I needed it, it didn't take too long to design with my very limited design skills and since it lives under the printer where it's hiding all it's flaws, I call it good enough.