September 14, 2023
Description
My Radmission 1 has done quite a few miles, but fairly early on I noticed my fuse cover fell out.
The replacement fit snugly enough (if anything - too snug) and has kept it covered. I printed it in PLA. Might be easier to fit/remove if it was TPU. Temperature wise PETG might be a slightly better bet, but if it gets hot enough to melt PLA, you've likely got bigger problems than a tiny plastic fuse plug can handle.
As a bonus I also made a cover for the battery plug for times when it was wet outside and I took the battery with me for charging/safety. This works better with TPU. PLA version was hard to fit/remove.
License:
Creative Commons — Public Domain
10
Pyro
