Birdhouse 32mm / 36mm hole

This birdhouse is fully printed, no additional parts required. 
To mount it, first insert the 32mm ring into the front and fix it with the clamp from inside. Than mount the roof on the body before you screw it onto a tree or pole. For this simply slide the roof onto the body from the backside.
After this, mount the front, using the four clamps, which are pressed into the 4x4mm holes at the body and front. Consider the different clamps for each side.
At the end, put the bottom in place from below. The bottom hangs loose in the body.
For cleaning, you can take out the bottom by lifting it and turning it.
The four clamps are 2 x “clamp for front” in original orientation and 2 x “clamp for front”, mirrored horizontal.
The only small supports are needed for the 32mm ring.
Printed with PETG, 0.4mm nozzle, 0.2mm layer height.

I added a 36mm entrance hole with a perch. If you printed the birdhouse already, you can simply replace the 32mm entrance hole with the 36mm hole and perch. The perch is mounted from the backside of the plate of the entrance hole. You can glue it, but it is not required.
It is mounted as described above for the 32mm ring.

If you want to print the birdhouse completely with the 36mm entrance hole, delete the 32mm ring from the “White parts.3mf” and print the “entrance 36mm.3mf”.