Travel tongue scraper Scraper for a few uses, when you travel, you can throw it away and print a new one at home. After printing, pay particular attention to the adjustment of the blade - when I set the layer height to 0.15 or 0,2 mm, the edges of the blade were printed correctly, they were not sharp - but I still recommend sanding the side edges of the blade with fine sandpaper and smoothing it with a flame as shown in the picture.
The scraper is flexible, does not press on the tongue, the rise of the layers provides a good grip to hold.
Try to run the scraper over your hand or your finger, if it is not too sharp - so that it does not injure you.
Print from light materials so that possible dirt can be seen.
You can clean it in mouthwash or isopropyl alcohol, which you use at the printer. After proper adjustment, the scraper should be safe
The author is not responsible for incorrect use of the model
Thorin Oakenshield
