AMS, EASY PRINT..STAY ON BED AND DON'T MOVE.... Y - Splitter, the best out there PC4-UM2 or 10mm ends

connect multi AMS smoother and less issue than the bambu 4 way hub, Easy to Print, It prints without falling of plate and DOES NOT mover while printing to give you a high quality print that fit and works..

UPDATE: after printing make sure to insert the PC4-UM2 clips, then install the PTFE Tube, then your locking clip, then push the tube in a little more to make sure it bottom out inside for a tight fit so tube don't move.

if your tired of failed splitters that don't print or work correctly.. then look no further…

the PC4-UM2 the ends just snap in and can be picked up on amazon..

both of these print perfectly, i do recommend using the PC4-UM2 version, super light. for those who have a bunch of the standard 10mm ends they work perfect too

NOTE: the 10mm ends all 3 will need to be tapped by hand, easy to do if you have the tapered tap to do it with, if you don't have a tap already cheaper to but end for the PC4-UM2 version

NOTE: both version you just clip off the supports on bottom, they are one of the reasons these print so well, they stay on bed and prevent moving during printing.. i been using this for over 6 months on all my printer, never had a jam up in the splitter..

if you have feed back please let me know, if you print it and it works for you please like it..