Bambu Lab Y-Splitter with PC4-M10 pneumatic connectors and 10 x 2.65mm magnets

Remixed For two 10mm x 2.65mm round magnets.
Center fillet was not working in Rhino, so I just lofted a surface.

I printed this in PLA with the suggested settings. I had to clean out the X1 side a bit. I'm not sure if it was filament from the support interface, or unsupported housing filament that was a little stringy. I also had to switch from auto to manual supports to eliminate some unneeded interface filament showing up unattached to anything after slicing. 

• Layer height: 0.08mm

• Walls: 4

• Infill: 25%

• Infill pattern: Grid

• Enable Support: YES

• Support Type: Tree (manual)

• Support Top Z distance: 0.45mm

• Support/object XY distance: 0.5mm

After about 2.5 years these seem to wear out if you use carbon fiber filled filaments periodically. You can reprint, or buy a splitter online.