Backdrop for Wexagon - Hexagon Shelfs Vol 1 - Homelander, Batman, 3DPN, 3DMN

These are backdrops to compliment the Minis created by Wekster and they plug right into the Wexagon - Hexagon Shelfs he has made.

This is the first batch of 4, I plan to make a backdrop for each mini that he has made.
https://www.myminifactory.com/object/3d-print-wexagon-hexagon-shelves-101570

Yes the pegs in the back are off center but that is because the infill it is plugging into is as well, so I offset it on the back to center the backdrop.

Support me on Patreon:

Print instructions

All of these are done with filament changes every 1mm in print height. Some only require 1 swap, some 2.

To have the pegs fit into the infill you need to make sure the shelf infill is hexagon at 15% infill. Or you can forget the pegs and just glue it on.

For the 3D Printing Nerd (3DPN) and 3D Maker Noob (3DMN) if using Prusaslice make sure detect thin walls in enabled if not parts will not print.

All the backdrops use the same pag in the back, a special one was included to use with 3DPN because it is cut.