Charging butler / iPhone + Watch + AirPods Pro wall mount charger

Charging butler /  Apple iPhone, Watch, AirPods Pro wall mount charger with Apple “Standby Mode” support in iOS 17 and with integrated 65W power supply to have 1 visible cable on the wall only for a cleaner look... 

When charging these 3 different devices you usually end up like this:

3 chargers, lots of visible cables and the usual tangled cables…

Using such a combined charger with 3 or 4 outputs will help to reduce the amount of chargers to deal with already, but you still have all the cables with all their downsides…

So why not put all this stuff in a case to hide the cables?

Well, this is my solution, because I wanted a clean look on my wall charger and i wanted to be able not only to charge the iPhone and Watch… I wanted to have a dock to put the AirPods Pro too…

PS: Works with stiffer and thicker wristbands too. =)

While designing this holder I thought that it looks like a little human that spreads its arms… So the idea to make a butler out of it was born, because the holder will serve you as a charging butler… Hope you like it. =)

The iPhone can be used in regular position or rotated 90° to be used in the new “Standby mode” of iOS 17.

The holder is large enough for an iPhone 14/15 Pro MAX + Apple Watch + Apple AirPods and all devices can be charged at once with good speed due to the good power supply. All cables are hidden inside the case.

Parts needed:

• 65W power supply from UGREEN (Amazon GER) or UGREEN (US) with 2 USB-A (Apple Watch + AirPods) and 2-USB (Apple iPhone and 1 for future use…). This power supply will fit very good into the case but others with similar specs (70mm x 70mm x 30mm) might fit too.
• 3x 8mm wall screws
• 3x 8mm dowel if you have solid concrete walls like we use to have in Europe…
• 4x M3x8mm screws to mount the holder to the lid which is attached to the wall
• 1x Apple MagSafe
• 1x Apple Watch charging cable
• 1x Apple Lightning cable for the AirPods

Mounting the parts:

1. Mount the Lid part to the wall. The 3 screw holes in the lid have a 7.5mm diameter.
2. Route the Lightning cable from the inside to the right arm and press it in place.
3. Press the iPhone MagSafe into the Holder part and route the cable to the inside.
4. Press the Apple Watch charger into the Holder part and route the cable to the inside.
5. Connect the USB cables into the charger and route the cables inside the case to save space.
6. Connect the power cable into the charger through the hole in the bottom.
7. Press the Holder part onto the Lid part and secure it in place with the 4x M3 screws.
8. Attach the power cable to your mains source.
9. Enjoy =)

Printing instructions:

• 0.2 speed profile
• Supports from the print bed for the holder part
• Textured sheet used
• Color change used at 1mm and 2mm to get the butler look =)

Happy printing =)