September 26, 2023
Description
I've remixed the model by Dr.D to be able to use it with wider range of raspberry pi cameras and without screws.
The holder should fit any camera with the front apparatus not exceeding 18x17mm (assuming it's at the the center of the PCB) and PCB not exceeding 26mm in width.
The holder should be printed with supports, the backplate can be printed without supports.
It's recommended to print the holder with a layer height of 0.2mm or lower.
Remember to repeat first layer calibration after mounting the holder.
License:
Creative Commons — Attribution — Share Alike
7
Ferrugius
