Rotatory mirror holder base

For a 150-144mm in diameter mirror (mirror and housing).

My mother makeup mirror base broke so created a new one which is a lot better.

You are going to need one M3 heated insert (goes to the base) and a M3 screw 10mm or less in length (10, 8, 6 will work fine). The heated insert goes in the base, you can put it from the bottom or from the top "cube" part. Then the screw goes from the top after putting and aligning the arm.

You do not need any kind of support, even my CR6 SE could do the rounded parts without any problem. Models are aligned as the way they are intended to be printed.

Category: Replacement Parts