Parallel Wire Stripper

I created this Model to strip only a small end of parallel wires (for WS2812 LEDs). I needed 170 of them so I looked for a better way.

Build:

Printed the parts.

Use a snapp-off blade, the small ones, with 9mm, break it into two parts.

Insert one half into each part and push all the way down. Do not hurt yourself!

I added a Supaclip (a kind of paperclip) and bent it, so it acts as release spring, for easier operation. this one I glued into the hole on the side. 

This model cuts the insulation of a 22 AWG well.

For fine tuning you could add some single wires underneath the blades.