Wet Wipes Lid - print in place

The model is a lid attachment to a standard wet wipes package's opening to replace original sticker cover, which tends to lose its stickiness over time, so the package remains open, and the wipes lose their moisture. 

Just tear the sticker off, insert bottom part in the opening perpendicularly, rotate it to place and cover with upper part till it clicks to hold everything in place.

This lid is reusable and transferable – just hold wider bottom part in the middle of longer sides with two fingers and rise the top part carefully. Steel ruler or knife can be used as prying tool as well.

Since the lid contacts with moisture, it’s recommended to print with PETG. This is relatively simple model to print: 

• It consists of only three small parts, two of them are connected to be printed in place.
• No supports are needed.
• It takes only one hour to print at base speed of 80mm/s. 

30.9 UPDATE: Released v2 version: 

• Bottom part's brim is wider and clips are stronger to survive more clicks
• Matched the brim of top part with bottom one - better and stronger wipes package's opening fixation
• Added fillets on the eges of the brims - easier to detach the top from the bottom using fingernails