BL Touch Mounts for Aquila HeroMe Gen 7 Aquila Remix

Included BL Touch mount didn't work for the dual 5015 setup I wanted to run with the direct drive mount I had at the time, and also didn't sit in the groove 100%. BL touch mounts for the original Hero Me didn't work either.

Decided to design up two variations:

1. A parallel arrangement to sit in line with the hero me base (probe offsets X = -38, Y= -5); and,
2. A perpendicular arrangement to sit out at 90 degrees from the hero me base. This is offset from centre to allow for mounting dual 5015s and will not interfere with the end stop switch (probe offsets TBC).

Both have captured nuts for an M3, although might be a bit tight depending on dimensional accuracy of your printer.

They both also feature cable slots inspired by some of the integrated BL touch mounts in satsanas.

Print inverse to installation, in the material of your choosing and around 20% infill should be sufficient.

Fusion 360 file included. 

Ferz out.