T-Caliper

Hello Gentlemen, this is an addon for your caliper in order to trasform the orginal one to a T-Caliper to use to measure deep holes,steps, others.
I adapted it to my caliper MIB Germany 200 mm, but it is very to adptive modfing the drawing. Inside the hole for the caliper arms i add a little slide to avoid problem when you will block it by screw. The hole for the screw has been made in ordet to add a M3 RUTHEX insert. In order to tighten use a M3x12 screw

Print Settings

Printer:

Artillery Sidewinder X1

Rafts:

Supports:

No

Resolution:

Infill:

15%

Filament: GEEETECH PLA RED "Strawberry Haribo "

Category: 3D Printing