Powder through die and funnel

Files for .223 Remington, 308 Winchester, 300 ACC Blackout, other cases may fit.

When reloading on a turret or progressive press without using a powder dropper the necks of the cases can be crushed by using the lee powder through die unless there is a gap between the case and the powder through die. With fine ball powders this can lead to some leakage.

This die is spring loaded and is designed for the case to make contact with the die and lift the centre part slightly to ensure a powder tight seal.

The centre part is spring loaded by either 2 small elastic bands or 2 x 18mm extension springs held on to the die body with 4 x M3 x 10 Allen screws. The holes in the Die body will allow these to be screwed in directly.

Also there is a file for an off set funnel as the standard lee funnel hits the other dies on my progressive press

When in use the inner powder through part should lift no more that 3/8" or 8mm.

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

Resolution:

.20

Infill:

Filament: prusa PetG galaxy black

Notes:

Category: Sport & Outdoors