This is the printable box for Pragotron/Elektročas/IBM pulse generator.
use PETG, 0.2mm, 350g, full filling
- The main power supply is done by 24V external source (either use a 24/2A rectified transformer or the original Pragotron ZZ24 backup power supply). If you use a backup source, there will be no power failure in the event of a power outage. For inut power and outpus of the pulses use 2,5mm DC connectors DC-022 2.0 by CONRAD - Buy or Repair at Radwell - Radwell.co.uk
- The electronic components are powered by a DC/DC converter 24-5V Mean Well SD-15A-5. On its place is holded by 2 screws M3x10
- For assemble the electronic components follow the instructions from site https://www.instructables.com/Pragotron-Generator-Pulzu/ All the electronic bordes are only clicked not screewed.
- The Elektročas KH-1 control clocks are used as an analog time indicator. The holes in the upper part of the box serve for their fastening. They are held in place by three M4x12 screws.
- 3 pushbuttons are KLS-pbs-009 (for main switch and setup ones with aretation, for reset without it).
- Top cover is holded on the base plate with 4 screws M6x12. After print all logos fill with white paint for better look.
jawarmaniak
