October 12, 2023
Description
This plug is designed to be used to plug the hole in your engine case, left when you remove OEM TDC sensor.
Dimensions are so that it needs to be hammered in and it stays in place good. Friction fit.
BUT SINCE IT IS DESIGNED TO BE INSTALLED FROM FLYWHEEL SIDE! I RECOMMEND YOU TO USE EPOXY GLUE JUST IN CASE!
It goes with out saying, use this design with your own consideration.
Use filament that can stand oils and higher heat.
I used Polycarbonate. ASA and even PETG should work as well :)
License:
Creative Commons — Attribution — Noncommercial — Share Alike
8
Edy195
