Playseat Revolution - Pedal support

I suggest you print it like this:

1. Top and the Bottom part
2. Then measure how long arm do you need in between. The lengths are measured from hole to hole.

There are different lenght arms, because the length depends on your pedal holder angle.

Additionally you will need:

• couple 6 mm bolts (for the top part).
• two 8x50 mm bolts for the joints.

You can print some knobs for the bolts, but I tightened them with wrenches.

And finally! The top part does not have the two bottom holes like in the picture. I drilled them afterwards and I am not going under the table to measure them to the right place right now. 😅 They are probably not needed, but you can also drill them if you want.

Please also check my wheel support for the same rig.