Quest 3 Touch Controller Wall Mount

I wanted a wall mount that would hold the Quest 3's controllers without risk of them slipping out or getting damaged.

Settings used:

• Layer Height = 0.20mm
• Walls = 3 
• Infill = 20%
• Supports = On
• Brim = On

Small amount of support required for the ends of the arms, may get away without support, but I would recommend them being enabled (example pictured)

I created this by approximately profiling around the Quest pro controllers to have a bespoke fit, so this will NOT fit the Quest 1 or 2 controllers (due to the rings and slightly different design).

There are 3 versions, one that has a screw mount (recommended), a riskier double sided tape mount (untested!) if you can't drill into walls etc. and one compatible with the Skadis T-Clip system.

Changes 16/10/23:

• Added Skadis T-Clip mounting method

Headset mount: https://www.printables.com/model/615721-quest-vr-headset-wall-mount